お客様サポートサービス

• The owner and relevant contact information.
• Service implementation site and environment conditions (site/equipment room/installation space).
• Device model, quantity, and configuration requirements.
• Device power supply conditions (power, grounding and so on).
• Interface type and routing conditions.
• Installation location, temperature, humidity and other environmental conditions.
• Service implementation time table.
• Other relevant problems.

• Assist customers in planning cabinet installation in terms of power supply, heat dissipation, load-bearing capacity and cable layout based on the device configuration to be installed.
• Assist customers in unpacking and checking.
• The cabinet integration and the main device installation.
• Install the transfer board and modules according to the design document and install filler panels in vacant slots.
• Connect and route the power cables and grounding cables. Tie cables and lay labels according to customer requirements.
• Connect and lay relevant signal cables (excluding the client's optical cable, network cable, such as the service cable between the switch and device network port). Tie cables and lay labels as required.
• Check whether the hardware installation is completed or not.
• Check the device input voltage, device power-on, whether the device can operate normally, and whether the indicator works properly.

Equipment debugging:

• Connect the configuration cables of the out of band management network according to the design to ensure remote management.
• Configure BIOS, BMC and RAID as required.
• Escalate BIOS, BMC and CPLD to the latest versions of xFusion.
• Check the software and hardware implementation specification according to the product specification.

Device acceptance:

• Check the device information to ensure the consistency with purchasing information.
• Conduct quality check on the server installation through FusionServer Tools.
• Acceptance document signing
• Consolidate the relevant documents and materials, and complete basic use training (the position and function of frequently used components, and minor faulty analysis).

• Equipment room environment design, power supply and heat dispatch review.
• Network design (planning solution and design) ,review and optimization (network topology and network protection).
• Service and data migration implementation.
• Third party hardware and software installation and configuration.
• Services provided in non-standard working time period.
• Unlisted services in other service instruction.